Mudjosh's Electricity
From FSG Wiki
| Mudjosh's Electricity | |
|---|---|
| [[Image:[None]|300px|]] Mudjosh's Electricity for Burning Sand 2 | |
| Creator: | Mudjosh |
| System: | Burning Sand 2 |
| Date of Release: | November 17, 2007 |
| Current Version: | 1.0 |
| Mod Type: | Game |
| Forum Thread | |
| Interface made by inferno, also icons by Neilnapier. | |
Ok.. Pretty much this mod is a BS2 version of Plastik's
The Guide
- Lightbulbs:
To make a light brighten, just make a battery. Make a red or white light bulb then make a wire or insulated wire connecting the lightbulb to the battery.. Power should surge though the wire into the bulb creating a glow.
- Powered Sources
The powered sources are the same. Just connect wire into the source while it is attached to a battery or other power source and presto you have water or oil.
- Nuclear Reactor
This is the most modified part of Plastik's old mod..
- First make a Square of Reactor to form a chamber(#1).. (The thicker, the better..).
- Then make another chamber(#2) to the side and make it higher than #1 but still connected.. (This will be to pre-heat the water..).
- Then add a Powered Water source at the top of the chamber(#2).
- Add a Water Heater in the middle going from left to right (Or right to left) in chamber(#2).
- Then add a way for the water to get into the upper half of Chamber(#1).
- In Chamber(#1) create a line (Horizontal) in the middle. (Not to thick but not to thin either..).
- Then add a Steam Generator at the top of the Plant. Use a wire to connect the steam generator to the water source.
- Add a touch of steam in the top half of Chamber (#1) to get a flow of WarmWater coming from the Water Heater.
- Then add some nuclear rods in the bottom half of Chamber (#1) and the electricity will stay flowing!
- Natural Gas!
All you need to do is create a box out of Wall. Then create a restricted pathway in the center place some vertical lines of Burner in the restricted pathway. Then place a line of titanium on the top of the box so that there is no more wall. (Just on the top) Place a cooler on one side and put some Natural Gas beneath the plant. Make a "steam box" above the plant by making three lines of wall using the titanium from earlier as the bottom of the box.. Place some water in this box. Put a steam generator (from the nuclear group) so that the steam can touch it. Let the gas flow into the plant and make a wire connect from the generator to a lightbulb and you are finished!
***NEW*** with version 1.0
Filaments:
To get the new light bulbs to work in the advanced section make a good sized lightbulb. Put a 8 Pixel line of filament in it. Connect Wire (Not Insulated Wire) to the filament. Then Put a Battery of your choice (in the advanced section) on the wire (not insulated) you may then add a resistor to slow down how many charges hits the lightbulb per second..
I will include pictures later on..
---
Notice: This mod is still small.. There will be big changes as time goes on.. If any of this info become irreverent, PM me in the forums. Thank you!
